PDA

Click to See Complete Forum and Search --> : Mirroring in Novell 4.11 After Installation?

houseisland
May 7th, 2001, 02:29 PM
How does one go about installing and mirroring on a second hard drive on an already established Novell 4.11 server?

The books at hand are all very clear on how to do this during installation but are mum about how to do it at a later date.

Thanks.
MacGyver
May 7th, 2001, 02:36 PM
Hey houseisland, haven't seen you around for a while. Anyway, if you ever need to access Netware 4.11 install options after the initial install, type LOAD INSTALL at the system console. Then go to "Disk Options" to configure mirroring. Just be careful with this utility, you can do some damage if you aren't careful!
houseisland
May 7th, 2001, 02:43 PM
Thanks, MacGyver.
houseisland
May 15th, 2001, 10:09 PM
Thanks again, MacGyver.

It went extremely well apart from taking two years for the mirror to generate.
cyberhh
May 16th, 2001, 02:46 PM
Keep in mind that some of the best NetWare information I have ever recieved was from people on this site. - Good luck.
MacGyver
May 16th, 2001, 04:07 PM
I am going to be upgrading the hard disks in our office server in about 5 minutes, and I have been advised NOT to let NetWare do the mirroring, but to use ServerMagic instead. Goes a lot faster!

Originally posted by houseisland:
Thanks again, MacGyver.

It went extremely well apart from taking two years for the mirror to generate.