PDA

Click to See Complete Forum and Search --> : Norton Ghost Peer-2-Peer

Gollo
November 19th, 2001, 12:41 PM
Ok I got the drivers for both my nic's I followed the help files from the symantec website and was able to connect the two systems (at least that's what it said) but I can not see the slave systems hard drive (the one I want to copy). All's I see is my hard drive. I have looked all over in options and haven't found anything wrong. Anybody got any input? Thanks.
shamus
November 19th, 2001, 12:48 PM
[quote]Originally posted by Gollo:
<strong>Ok I got the drivers for both my nic's I followed the help files from the symantec website and was able to connect the two systems (at least that's what it said) but I can not see the slave systems hard drive (the one I want to copy). All's I see is my hard drive. I have looked all over in options and haven't found anything wrong. Anybody got any input? Thanks.</strong><hr></blockquote> According to what I've read the machine with the drive you want to copy needs to be the master not the slave, depending on what your doing (partition to partition , disk to image, etc.)
Gollo
November 19th, 2001, 12:58 PM
I've tried it both ways and have not been able to see either of the two computers physically (because the connect I know they are talking to each other). I'm using the NDIS2 drivers for both systems. Thanks.
GHSTECH
November 19th, 2001, 01:22 PM
You are getting ights on the nics, right?
If not are you using a crossover cable or a hub/switch to connect the system?
Gollo
November 19th, 2001, 01:24 PM
I'm using my d-link704 router/switch to connect. Could this be causing the trouble?
GHSTECH
November 19th, 2001, 06:41 PM
I would try a crossover cable between the two. The system to system ghosting was orginally done by using serial or parallel cables to connect the systems. So the technology my not allow for a hub/switch to be in the middle.
Gollo
November 19th, 2001, 08:03 PM
I read somewhere that this might be a problem. I'll try the crossover. Thanks.
Gollo
November 20th, 2001, 03:51 PM
I used the crossover and it worked but looking back I see that it worked with my router/switch but I just didn't make the connection because I have 3 partitions on the system were I wanted to copy the other drive to but two of them are NTFS and one of them is fat32. I didn't put 2 and 2 together and see that ghost can only read fat32 so I assumed that the computers werent connecting. Oh well I got the info that's all that matters. Thanks for all the input.