Using debug to remove partitions

[REI]

I had the code to enter when you run debug & lost it...

Does anyone out there know what I am talking about and could give me the code again?

[REI]

Never mind... I found it...

C:\>DEBUG
- f 200 L200 0
- a 100
xxxx:xxxx mov ax,301 (ignore segment http://www.windrivers.com/cgi-bin/forum/redface.gifffset values at left)
xxxx:xxxx mov bx,200
xxxx:xxxx mov cx,1
xxxx:xxxx mov dx,0080
xxxx:xxxx int 13
xxxx:xxxx int 3
xxxx:xxxx (Press ENTER an extra time here)
- g=100
(ignore register display)
- q (quits back to DOS)


IDE drives only...