Kingston KNE2021LC

[-sw-]

Hello,

I have recentaly salvaged a knigston Network card, a KNE2021LC..

I installed it hardware wise, downloaded the drivers but i think that i might need some sort of program to config the actual device. ( it has a distinct lack of Jumpers )

can anyone help me...
thanks

[CompuDocs]

You will probably need to run the setup program on the driver disk. It might be called something else like Diag or ksetup, but what it does is to allow you to configure the card. Then get the settings for I/O and IRQ. Make sure Windows matches those.

Good Luck.

[stevet]

On the page where you probably got the drivers, there are other programs available which look like they will allow you to program the bootROM. Try here:

<a href="http://www.kingston.com/download/etherx/etherx.htm#kne2000tlc">http://www.kingston.com/download/etherx/etherx.htm#kne2000tlc</a>

Steve

[sw]

thank you both for your replies.. it works now!
http://www.windrivers.com/cgi-bin/forum/smile.gif