Keith&Liz.B
May 22nd, 2000, 04:25 PM
Help needed with a plotting problem. We are not computer wiz-kids but just getting to grips with Autocad LT 97 producing acceptable drawings printing out on a Cannon 5500 Bubble Jet printer in A2 size. We have acquired a Benson Series 16, 8 x pen plotter, (yes, old technology I know but it prints out when working a very good copy).
The plotter is connected to a PC, Pentium 2, operating on Windows 95 via a Vdf Windows Driver. We can get the plotter to start a drawing but part way through it goes into "clipping" mode. We have checked our drawings for items outside the set parameters as per the operators manual but with no success.
Any help or suggestions with this problem will be greatly appreciated.
Old Plodders
K & D B
The plotter is connected to a PC, Pentium 2, operating on Windows 95 via a Vdf Windows Driver. We can get the plotter to start a drawing but part way through it goes into "clipping" mode. We have checked our drawings for items outside the set parameters as per the operators manual but with no success.
Any help or suggestions with this problem will be greatly appreciated.
Old Plodders
K & D B