[RESOLVED] Default Bios password for a fujitsu Ergopro e 450

[bannerbridge]

I am trying to build a half decent old fujitsu, i have put in a second hard drive but i need to set the bios to look for it. Problem is that it asks for a bios password and no one i know has any clue what the default is or how we can get around it...any ideas anyone?

[David Chiang]

Try using a Killcmos dos program to clear all bios setting to default.

give me a note if u still can not break the password.

david_chiang@hotmail.com

[jeffc]

Another way is to make a note of current settings on paper (what's that??)

Next you power off the pc and unhook the cmos battery - you may have to desolder it - and short the battery connecters (without the battery present) together for a couple (2 or 3 ) minutes.

This will wipe all cmos settings from memory including the password.

You will then have to refit or replace the battery and power on and go into cmos setup and configure using your desired settings.

It should be reasonably easy

jeffc