Click to See Complete Forum and Search --> : No Operating System Found!!!!
Austin4778
May 27th, 2007, 07:02 PM
well i tried booting my IBM computer up and it shows the IBM logo then after it shows that its supposed to load windows xp, but instead a blank screen appears like this saying:
1962: No operating system found. Press F1 to repeat boot sequence.
when i try pressing F1 it just says the same thing...no operating system found.
I purchased a new hard drive and installed that and it still says the same thing. I also have tried booting my windows xp recovery cd and it wont boot it up. i tried starting up the cd rom drive when the computer first boots up and it just goes to the blank screen says no operating system found. It doesnt even try to run the cd-rom drive. im lost CAN SOMEOENE PLEASE HELP MEE!!!!!!
street1
May 27th, 2007, 07:29 PM
I would recommend checking the BIOS for boot sequence or,trying a new CMOS battery.
Austin4778
May 31st, 2007, 10:05 AM
i tried changing the BIOS order, but i mean my computer worked fine until this happened....WHY DOES THIS HAPPEN TO ME!!!!!
markduren2458
May 31st, 2007, 11:20 AM
well...lets check the obvious first
1) does the computer recognize the drive? go in bios to check
2) go in and reseat drive cables
Ferrit
May 31st, 2007, 04:06 PM
After seeing you in the chat for a number of times and advising the recommended troubleshooting I can only wonder why you haven't gone and gotten a good known working cdrom and tried that
NooNoo
June 1st, 2007, 05:16 AM
Sounds like you put the new drive as master and the original drive can no longer be seen. Check the jumper settings on both drives... or did you take the original out?
Austin4778
June 2nd, 2007, 04:33 PM
im not sure but i pressed F1 when the computer booted to get to my settings. and i noticed it said neither hard drive 1 or 0 was installed. i believe my computer is having trouble finding the hard drive. i tried an external cd-rom drive because my cd-rom on the computer wont load and neither did the external cd-rom. the hard drive has been replaced and i still have the same problem. ANY IDEAS???
NooNoo
June 2nd, 2007, 04:45 PM
Yes. You have not adjusted the jumpers correctly and possibly not fitted the ide cable properly.
What is the make and model of both the hard drives?
Ferrit
June 2nd, 2007, 05:15 PM
Or as I expect the motherboard is dieing
markduren2458
June 2nd, 2007, 08:46 PM
unhook both hard drives from ide cable and hook only hard drive 0 up or the one the farthest away, reboot and tell us if and where the bios see it..primary master or slave