Code 10 USB Problems

[daveislost]

Ok, This code 10 thing started ever since I reinstalled Windows XP. I've got that sandisk player and when I plug it in it says '' Problem occured during hardware installation etc....'' So, I tried the whole uninstalling reinstalling junk with the ''usb mass storage device'' and restarting and the exclamation mark still came up. Tried updating. Plugged it in directly to the usb with the designated 2.0 usb. And i checked all updates.And I don't really understand anything else anyone posted concerning bios, the master thing, and stuff about the motherboard. I'm obviously new at this. Please help With anything you can pull from under your sleeves. I will forever be sad until then.:sad:

[Mayet]

Code 10 usually that USB is not all in there...or theres a conflict

Remove sandisk from machine
remove and uninstall all associated drivers

Make sure all motherboard and chipset drivers are installed and there are no yellow exclamation marks in the device manager, especially under USB.

go to miscrosoft windows updates and download all updates and service packs for your machine.

When complete and when device manager is clear of yellow marks

reboot into safe mode
install sandisk drivers
reboot and plug sandisk player in

http://www.sandisk.com/Retail/DriverDownloads.aspx
Check you are using the latest driver and for updates at above link.

[daveislost]

I Forgot this thing had a cd...... it was one of small ones.. The thing is i had two windows xp Settings in my comp believe it or not and now everthing i get goes 2 my D: drive so, Since I moved to the new one. so I had to use my cd again. But now i got a prloblem with the other setting. But I'll fugure that out... Thanx for the advice.

[daveislost]

Yah i just needed the cd thats all and i sent another reply but it went elsewhere. Thanx for the info on the code 10. I was goin nuts until i figured it out.... stupid me.