Printable View
What speed of pentium is this chip?
Here are the numbers under the CPU:
E5193973CD
A4
A80502-100
SX970/VMS
Also, what is the difference in setting a PCI Clk at /3 or /4?
What is the CPU clk level?
Thank you again for any help given
What are the proper settings for this chip?
its a 100
------------------
If it aint broke......use a bigger hammer
Try this site. It may help you out....
Is it safe to assume this is an Intel chip??
http://developer.intel.com/design/in...T/27318303.pdf
https://forums.windrivers.com/
------------------
Network Administrator
MCSE
http://www.dcinh.com
I'm not sure that damned angel is right. What type of socket is it in (socket 5,7,370, etc.). Does it say pentium on the chip? If it isn't in a socket 5,7, or 370 board, then it may be a 486 DX4 100Mhz, but I doubt that is the case.
The /3 /4 pci clk setting is to determine the pci bus speed. The PCI bus should normally run at 33MHz. It is determined by dividing the cpu bus speed by a constant (that's the 3 or 4). If the cpu bus speed is 66MHz (as is the case for pii and celerons and most of the early socket 7 pentiums) it should be set to "/2". 66/2 = 33. If the cpu bus is 100MHz (early piii's), set it to "/3." If it is a 133MHz bus (most recent piii's) then use "/4."
I have confirmation that it is an intel chip.
What settings should I set the motherboard to in terms of PCI clk timing....is it /3 or /4?
Also, What is the CPU clk level? Choices here are either 5 V or 3.3 V
It also has a CPU voltage jumper that's already set to 3.3 volts.
Hello,
It is a pentium classic motherboard. Triton chipset....microprocessor is an Intel pentium 100.
Sorry....forgot..
it is a socket 7 motherboard