e139761 pin settings

**NooNoo** · September 21st, 2004, 03:34 AM

Interesting, that serial comes up with a p200 mmx... looks like you have a hybrid there.

result of digging 1

result of digging 2

result of digging 3

result of digging 4 (no onboard audio)

If it's not one of those, I am out of ideas.

**nemoz2000** · September 24th, 2004, 02:32 AM

Originally Posted by NooNoo

Interesting, that serial comes up with a p200 mmx... looks like you have a hybrid there.

result of digging 1

result of digging 2

result of digging 3

result of digging 4 (no onboard audio)

If it's not one of those, I am out of ideas.

Eternal thanks, NooNoo -- it is a cross between dig 3 and the others. These boards must've been originally for P2 slot 1 but later they got used with the early P3 slot 1, which is where mine came from. The front panel connections are the same and I can see my error with the on/off button.

There is other good news in the data you found -- the ATX power connector on the Gateway is absolutely standard, so there should be no problem fitting a generic PSU.

Back to the workshop ...

**NooNoo** · October 5th, 2004, 12:48 PM

**sgtdraco** · October 19th, 2004, 12:13 PM

OK i just fitted a gatway motherboard and its running fine, if this is the board your looking for the pin outs on then i have listed all numbers on the pcb/motherboard so you can make sure its the right one.

All these nubers can be found on the pcb/motherboard.

E139761 - Next to the ide ports bottom end.

4000622 - Next to the ide ports bottom end on a sticker with bar code.

N232 - Next to the floppy drive port bottom end.

IMEA02400315 AA A19243-204 - Below front panel pin bottom on a sticker with bar code.

Remember that pin one on all jumpers is maked with a small white triangle.

The front panel pin block for this pcb/motherboard is a 16 pin block at the front side under the floppy drive port.

Front panel pin settings:

HD Led - 1,3
Power Led - 2,4
Reset - 5,7
Power On - 6,8
IR - 11,13,15

Hope this helps.

**convertisseurfou** · November 13th, 2004, 02:22 PM

hello,
is about the old motherboard E139761_Gateway ?
http://support.gateway.com/s/MOTHERB...M0026422.shtml
the diagram of the connector is erroneous, I created this bond where you will find an drawing with a correct diagram :
http://pageperso.aol.fr/Convertisseu...onnections.jpg

in a friendly way