-
February 12th, 2001, 03:36 PM
#1
[RESOLVED] winpicfg= fatal error
just got done installing new win98. installed netware NIC card but when i try and run winipcfg i get a message
"Fatal error
Cannot read ip configuration
-
February 12th, 2001, 10:43 PM
#2
Ok, first thing is to make sure you have installed all the drivers properly, by checking the Device Manager. Second, you HAVE to configure the network settings first. If it's an actual NETWARE card, is it set up for TCP/IP? You need to have the following installed in the Network dialog in COntrol Panel before you should try to use WinIPcfg:
Network Client (Usually Client for Windows networks)
Protocol (99% of the time that's TCP/IP)
Adapter (Your network card should appear here if set up properly. This is where you assign it static IP settings, such as IP address, and DNS/WINS servers, or you configure it to use DHCP to obtain IP settings).
------------------
Bryan Pizzuti
CompTIA A+, CNAP
[email protected]
ICQ # 8525092
Yahoo Messenger: npaladin_2000
Bryan Pizzuti
CompTIA A+, CNAP
[email protected]
ICQ # 8525092
Yahoo Messenger: npaladin_2000
-
February 13th, 2001, 03:32 AM
#3
if you have TCP/IP installed it might just be a corrupted Winsock (Virus ??)
run System File Checker
start-> Run -> SFC.exe
and restore damaged files..
------------------
Computers do exactly what you tell them to do - not exactly what you want them to do ...
-
February 15th, 2001, 01:12 PM
#4
dont know what the problem was. switch to my spare DLINK NIC card and works perfectly.
-
February 15th, 2001, 03:55 PM
#5
just wondering
how would i get a virus on a brand new installation of win98se?
-
February 18th, 2001, 02:20 PM
#6
can prob be solved by just removing tcp ip and all clients from network. but i would also go into Windows setup and remove communications.... then reinstall off the win cd.... gointo network and install all you your necessary clients and protocalls and set them up for your network...
hope this helps
------------------
They get mad when they come to raid my pad and i'm out in the nine duece cad.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks