[RESOLVED] NT4 RAS Problems

[latenight]

Changing from a Class C to a Class B on NT4, Ras has been giving me problems. You can dial in connect to the server by Netbui, but TCP/IP does not connect properly. Everything is fine locally you can access TCP/IP. The DHCP is doing it's job. It is only on RAS that there is a problem. It grabs an IP number but hangs when you try to get to the net. Any ideas would be appreciated.

[j-man]

You say that "You can dial in connect to the server by Netbui, but TCP/IP does not connect properly. Everything is fine locally you can access TCP/IP". It sounds like remote TCP/IP hasn't been configured. RAS can be configured with either NetBEUI,TCP/IP or IPX/SPX but the sys admin will have to configure your dial-in profile with whatever protocol you want to connect with. Also make sure that your subnet mask is correct. Changing from a class c to class b may change your subnet mask. The default subnet mask for a class C network is 255.255.255.0, a class B subnet mask would be 255.255.0.0

[This message has been edited by j-man (edited December 27, 1999).]