[RESOLVED] Fails to boot
Results 1 to 2 of 2

Thread: [RESOLVED] Fails to boot

  1. #1
    dude
    Guest

    Question Fails to boot

    Actually it's worse than that. When you apply power the HDD powers up then the floppy runs then it gives 2 short and to long beeps and that's it,no display no nothing. Here's the info that I can find- Case says- AT&T Globalyst 375TPC
    Motherboard says-AT&T 3248/3348
    WD hard drive
    On board video(tried adding card no change)
    bios chip sticker- FBIOS 3248/3348
    (C) Phoenix 1994
    (C) AT&T 1994
    Penium processor
    Can't find info anywhere on this POS the owner says his wife checked her email and then shut it offwihout waiting for windows to close and when they tried to turn it on again this is what they got.
    Any ideas ? (besides using it for a boat anchor)
    Thanks

  2. #2
    Loneranger
    Guest

    Post

    Hi Dude ; the symtoms seem to indicate a memory probem , try reseating the memory chips , memory might have gone bad ,make sure they are seated right and tight .


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •