-
May 30th, 2001, 05:38 PM
#1
Registered User
broken cpu retention tab - adhesives?
I did it, snapped it off clean trying to remove a stubborn heat sink.
I'm thinking about using some kind of adhesive to put the sink back on the chip. Anyone recommend anything that can be picked up at Zellers or a hardware store? I really would rather not have to order something from Supercom and wait for it to get here if at all possible...
I'd also appreciate warnings about any adhesives you have had BAD experiences with <IMG SRC="smilies/eek.gif" border="0">
Flash! Don't heckle the supervillain!
-
May 30th, 2001, 06:20 PM
#2
Registered User
what is the chip? socket? slot?
"You've been livin' on the razor's edge, since you began to shave...
Make sure you live, you're a long time dead, cradle to the grave"-Motorhead
-
May 30th, 2001, 06:40 PM
#3
Registered User
Socket 7, lower end Pentium, not overclocked.
Flash! Don't heckle the supervillain!
-
May 30th, 2001, 07:02 PM
#4
Was it the tabs aligned with the centre line of the CPU socket that broke?, If so, look for a fan with the type of retention spring that goes over the tabs nearer the edge of the socket. I've had this problem before.
I think I know just enough to know how much I don't know... I think...
-
May 30th, 2001, 07:27 PM
#5
Just use silicon paste, if you cover the center of the CPU it WILL not go anywhere, I have had to pull very hard to get them off when silicon paste is on them.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks