HELP! , I have nt4 sp4 installed and need to install windows 95 without formatting or loosing any data. I know the procedure should be like this :

Make an emergency repair disk (rdisk - Update Repair Info)
Ensure you have NT installation disks (can make by winnt32 /ox)
Reboot the machine and boot off of the MS-DOS disks
Install DOS (same as doing a SYS a: c: from a dos bootable disk)
Machine will reboot into DOS
Reboot Machine and boot off of NT installation disks
After 2 disk will give options, press R for repair
Deselect all options except "Inspect Boot Sector" and continue
Press Enter to detect hardware and insert disk 3
The procedure will ask if you have an Emergency Repair Disk (ERD), say Yes and insert the ERD.
The machine will then reboot into NT again
Once in NT goto a DOS session
Type - attrib c:\boot.ini -r -s
edit boot.ini and insert at the bottom
c:\="MS-DOS"
Type - attrib c:\boot.ini +r +s
Reboot the machine and you will have MS-DOS and NT options! Easy :-)
The procedure above will only work if the C drive is FAT.

problem is after sys c: command .... machine will not re-boot.... it just sits there with the cursor in the top left and the HDD light constantly on ..... any ideas ???

Thanx , im getting desperate now