A friend was having compatibility problems with his printer and scanner so I
got him a USB to Parallel (CA930) cable to connect his printer, a Canon
Laser, to one of the USB ports on his PC. I followed the instructions and it
plugged and played and installed the driver from the floppy disk.

I then tried to print and it worked fine.

However, after re-booting, it would not print and came up with an error
message.

On the floppy which came with the cable there is a file called 'Cleanup'. If
I run this it clears out the drivers and reboots the PC. On restarting
Windows 98 SE, the driver re-installs and the printer works again.

It does not seem the load the driver on restart unless you run the Cleanup
file before restarting.

Any idea why this may be.

The other problem is that I re-connected the normal printer cable to the
PC/Printer but this will not work at all now whereas it did before.

Any advice would be greatly appreciated.