I remembered the opposite... I had to run OEMUSB.EXE to make the muthas work the other updates usually failed on me and wreck vmm32.vxd
When you install oemusb.exe it installs uhcd.sys to your windows system folder. Go into device manager usb properties and point there to update the driver. I've done it a few times, it always worked for me.
And Control Enter STILL wont let me post a reply.
Just tried the link , it works fine ?? I've always used this to install USB , never was able to make the USB file on the CD work , not disputing Darren , if he says it does , it does , I just can't seem to figure it out and didn't waste much time trying.
That is the link to 4.03.1214 !! And yes the link does work , I just tried it again ,but maybe its picking up info from my internet cache , go to the Windrivers busmastering page and its the first item in the Intel file. I've never needed anything else to get the USB running ,be sure the USB support is switched on in your CMOS ,load the file from within Windows and reboot , should find the USB and hub without a problem.......thats should , not will !!
[This message has been edited by Rkring1 (edited February 09, 2001).]