[RESOLVED] IDE CD-Rom
Results 1 to 2 of 2

Thread: [RESOLVED] IDE CD-Rom

  1. September 6th, 1999, 03:57 PM #1
    DaveK
    Guest

    Resolved [RESOLVED] IDE CD-Rom

    Trying to get an IDE CD Rom to work, but receive "CDR101: Not ready" error. I am booting from a clean floppy, and the system seems to correctly identify the drive, and load MSCDEX (v2.25) - but that's as far as I get - and I've run out of ideas. This is a brand new drive, and I have tried switching the cables, changing IDE channels, and switching with the HDD. Any new ideas would be most welcome!!

    Dave
    Reply With Quote Reply With Quote
  2. September 12th, 1999, 02:18 PM #2
    BA919
    Guest

    Talking

    Sounds like your new cd-rom may be jumpered incorrectly. Check the manual. If you have it as a slave to your Primary HDD, ensure it is set as so.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules