-
April 17th, 2001, 03:09 AM
#1
Reassign drive letters in W2K ??
I'm using a raid pci controller with the attached drives as my primary. Next is an adaptec scsi last is an IDE 14gig.
Bad thing is that when the fresh install was all said and done it defined the IDE as primary and scsi second with my raid system as the E:drive ???
How would I reassign these settings within some form of admin mode?
thanks,
D1
3POINTWEB Biz Services
909-899-0728 (OFFICE)
909-292-2245 (FAX)
-
April 17th, 2001, 03:15 AM
#2
right click on My Computer, select manage, and go to Disk Management to reassign drive letters, etc.
"Badges? We don't need no stinking badges."
-
April 17th, 2001, 09:07 PM
#3
"Cannot modify the drive letter of your system or boot volume"??
This is the error message is tells me when I attempt to change the lettering swapping my local preferred boot drive E to C and the C to a J drive.
Thanks,
D1
3POINTWEB Biz Services
909-899-0728 (OFFICE)
909-292-2245 (FAX)
-
April 17th, 2001, 09:22 PM
#4
Registered User
um...you can't change the drive letter of your system partition once it is installed without a 3rd party software
"Only two things are infinite, the universe and human stupidity, and I'm not sure about the former."
- Albert Einstein
-
April 17th, 2001, 10:02 PM
#5
I had the same problem with W2K at home. using IDE drives. The primary master drive I installed to came up lableled as e:\. I tryed to change it but to no avail. weird.
I'm just a little mushroom. always kept in the dark...
-
April 18th, 2001, 04:35 PM
#6
Registered User
didn't read the article but i believe this is what you want
http://support.microsoft.com/support.../q223/1/88.asp
I'd rather be riding my motorcycle
"I gotta have more cowbell, baby" Bruce Dickinson(Christopher Walken)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks