-
January 18th, 2001, 11:33 AM
#1
Netbui ?
I am networking two NT4.0 Workstations. I was wondering what anyones opinion was on the best protocol to use. I was going to use Netbui, but I just used TCP/IP and used assigned IP addresses. It seems to work OK, but I have heard Netbui would be faster and easier. Any thoughts ?
------------------
"You gonna pull those pistols, or whistle dixie ?"
-
January 18th, 2001, 01:07 PM
#2
For small networks NetBeui is faster. It is also a higher level protocol allowing for better broadcasting. However it is a more active protocol than IP so don't use it with more than 20 PC's on the same network.
------------------
Death is lighter than a feather - duty heavier than a mountian.
Death is lighter than a feather - duty heavier than a mountian.
The answer to your question is: 00110100 00110010
-
January 18th, 2001, 01:09 PM
#3
netbeui is for small networks that you dont need any support for routing, or internet access for that matter... very easy to setup, very easy to admin , if you want net access...stick with tcp/ip
*mutters cause someone else responding while he was typing out his post!*
------------------
Quote the madcow, 'Never Moo'
[This message has been edited by morguth (edited January 18, 2001).]
-
January 18th, 2001, 01:54 PM
#4
don't run netbeui. if your going to share/use the internet with both machines use tcp/ip. multiple protocols slow your machine and most people wind up wanting to access the internet with both machines eventually.
------------------
=-iateyourcat-=
-
January 18th, 2001, 08:49 PM
#5
There is one good reason for using NetBEUI along with TCP/IP. Since NetBEUI is non-routable, you can bind file and printer sharing to it, and unbind it from TCP/IP, and this will help increase your security. Be sure to unbind NetBIOS from TCP/IP as well.
------------------
Captain Troy D. Pack Rat
`akbar Press
If you're furry and you know it, hug the mouse!
-
January 20th, 2001, 11:51 PM
#6
NetBEUI is a much faster protocol then TCP/IP for smaller networks. Use it for your file/printer sharing and reserve TCP/IP for Internet access. NetBEUI will broad cast to the entire network at once though so once you start adding multiple boxes it can cause a lot of network traffic. Since NetBEUI is not routable you are limited to one subnet with it.
Also as a note, with the introduction of the Whistler OS, Microsoft is removing support for NetBEUI
------------------
Net Appliances: The Next Generation... The USB Toaster.
-
January 23rd, 2001, 03:37 PM
#7
as Compaqman and other stated netbui is very fast on local area networks all you have to do is change binding on tcp/ip disable binding to file and print sharing this will make netbui do all local trafic between sets and you can use tcp/ip for internet this will also give some minimal added security on internet you dont want tcp/ip with file and printer sharing on the net. X
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks