[RESOLVED] LAN wire
Results 1 to 3 of 3

Thread: [RESOLVED] LAN wire

  1. #1
    THROUEAME
    Guest

    Resolved [RESOLVED] LAN wire

    This is the problem: Can I connect two 10/100 ethernet adapters without passing through an HUB? How should I make the cable? Simply inverting all the wires in one plug?

  2. #2
    Registered User
    Join Date
    Jun 1999
    Location
    Las Vegas, Nevada
    Posts
    1,109

    Post

    If your going from NIC to NIC without a hub, then you would need a crossover cable.
    Here's a link, to show how to make one.

    http://www.duxcw.com/digest/Howto/ne...cableprint.htm

    ------------------
    An obstacle is something you see when you take your eyes off your goal.
    An obstacle is something you see when you take your eyes off your goal.

  3. #3
    x_789
    Guest

    Post

    One note make sure when you build this cable shown on the provided link to make a 568b type cable. The "t568a" is a standard that is not used anymore other than in the military any cables you use any more will all be a t568b that way if later you need to use this cable to link two old hubs togetherthat dont have uplink switchs you wont have to make another cable. X

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •