-
January 8th, 2004, 07:33 PM
#1
Registered User
Win2k Server setup - cannot format scsi drive
Hi!
I have a big problem. I'm trying to run win2k server setup and it cannot format one of my scsi drives, says there is only 0mb available on drive when creating a partition. I have another scsi drive on the same controller/chain and it is just fine according to Win2k setup. I don't know much about scsi so I could be doing something wrong, but Setup detects both drives correctly except of course when I try to create a partition/format like I said before. Any ideas?
Thanks!
system:
Tbird 1200mhz
ASUS A7v mb
256mb pc133 ram
Diamond FirePort ultra scsi controller
2 4.3 gig scsi drives
DON'T PANIC
-
January 8th, 2004, 08:04 PM
#2
Banned
First rule of thumb with SCSI issues; be sure you are properly terminated, and the ID’s are correctly assigned (well that’s two). What controller is it, what kid of hard drives are they, and what type of termination are you using...?
I would suggest checking the webpage for the drives, ensure you have all of the jumpers setup correctly; there are several things that can cause a drive not to work.
Also, what does the SCSI BIOS tell you, is there a utility you can use to ensure the addresses are being assigned as you expected?
Is it possible the drive just doesn’t work? I have seen them not work right out of the bag…
-
January 8th, 2004, 08:13 PM
#3
Registered User
Ya_know! LTNS bud
I have no f'in clue if the drives are terminated correctly, but when I go into the scsi controller bios, it detects everything perfectly. I assigned first drive ID0, second drive ID1. Controller is using ID7. The drives are seagate cheetahs (about 3-4 years old) and I'm really not sure if they work at all. *laugh* I just pulled them out of a box, along with the controller. The ultra scsi cable itself has a small rectangular plastic and circuit "board" attached to the end of it, so I would imagine that it is the terminator.
One more thing to mention; I have 3 of the cheetah drives, and only one works thus far. I have tried changing IDs, switching cable positions, etc., but it's always the same drive that works. It's looking more like I have 2 dead drives and one good one. Thoughts?
DON'T PANIC
-
January 8th, 2004, 08:44 PM
#4
Registered User
If your controller has a low level format function try running that on the "dead" drives. It'll reclaim lost sectors (if possible) and tell if if there's a SCSI or drive error.
Deliver me from Swedish furniture!
-
January 9th, 2004, 10:05 AM
#5
Banned
Sounds like you have termination on the cable, which should work fine (unless it's not functioning correctly ). Be sure these drives don't have termination enabled on them via a jumper, three+ years old, they are sure to have that feature. (Again, get to the specs from the manufacturer, so you can get all of the jumpers defined)
Other than that, have you tried each drive on the controller individually...? The LLF is a good suggestion, it should identify if the drive is not working…
-
January 9th, 2004, 10:06 AM
#6
Banned
Originally Posted by techleet
Ya_know! LTNS bud
Oh, and: Hey Bud! LTNP (post)...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks