-
September 10th, 2004, 05:52 PM
#1
Strange behaviour with USB memory
Hello All!
I am new to this forum.
I have just purchased an Attaché USB memory (see http://www.pny-europe.com/uk/flash_attache.asp). Behaviour of the memory is dependant on when it is connected.
1. If it is connected during computer start-up and not removed at any time, the memory works as expected.
2. If it is connected when XP is already running, then the OS finds the device, but when trying to access the memory it will freeze the computer. If I disconnect the memory the computer works fine again.
My computer is a Fujitsu-Siemens P4 with XP home edition (Service Pack 1 installed).
I have 6 USB ports. I believe that 4 of them are connected to the mother board and 2 of them are on a separate card. The 2 one the separate card are USB 2.0 and I think the manufacturer is NEC. It does not matter which USB port I use, same behaviour on all.
A friend of mine connected his USB memory to my computer, and it had the same behaviour.
I have other USB devices, e.g. digital camera, and no problems whatsoever.
My best guess it has something to do with the USB drivers, but my knowledge in this area is very limited.
Any help would be very much appreciated.
/DTK
Similar Threads
-
By Perjan in forum USB/Firewire
Replies: 6
Last Post: November 25th, 2009, 07:29 AM
-
By Marinero in forum USB/Firewire
Replies: 14
Last Post: May 8th, 2004, 07:23 AM
-
By crazyzoop84 in forum USB/Firewire
Replies: 12
Last Post: April 15th, 2004, 06:09 AM
-
By Penman in forum Tech-To-Tech
Replies: 11
Last Post: March 30th, 2004, 04:51 PM
-
By johnmacf in forum USB/Firewire
Replies: 21
Last Post: March 16th, 2004, 07:33 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks