-
August 8th, 2005, 09:25 AM
#1
code 10 error
using windows xp sp2. get a " this device cannot start ( code 10)
when trying to load " prolific usb to serial port " usb gps receiver.
worked fine until I updated to sp2. Any suggestions ?
-
August 8th, 2005, 09:41 AM
#2
code 10 error
I reloaded windows and updated to sp2.
then when I tried to reload my driver for my gps ( prolific usb to serial port )
I now get a : this device cannot start" ( code 10 ) It worked fine before I had to reload windows. I figured I would go ahead and update to sp2.
-
August 8th, 2005, 04:28 PM
#3
Registered User
Similar Threads
-
By LANSTARR in forum Windows XP
Replies: 8
Last Post: October 18th, 2007, 02:24 PM
-
By ron_of_orange in forum USB/Firewire
Replies: 22
Last Post: December 30th, 2006, 07:06 PM
-
By anscenic in forum USB/Firewire
Replies: 0
Last Post: November 4th, 2004, 11:48 PM
-
By el_general in forum USB/Firewire
Replies: 15
Last Post: September 7th, 2004, 02:27 AM
-
By fedis_it in forum Digital Imaging
Replies: 3
Last Post: April 1st, 2001, 05:11 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks