The efforts to remedy the Event ID 9 errors on my two PC's
has finally exhausted itself. The results are disappointing.

Nothing I did worked.

Efforts included:

Replacing a mother board in my TYAN box.
Two (2) RMA's for the Firewire CD_RW.(they replaced the Drive and the Logic board)

I tried virtually every Microsoft "Hot Patch".

My conclusions:

The product provided by Ahead (Nero) named InCD is bad.
The product provided by Roxio "Drag & Drop" is bad as well but might be less so

I can only say one thing in thier defense. They may open once, run once, maybe twice, if you're lucky.

You might get better milage then I did, if so I'm happy for you.

The UDF format including Mt Rainier variations is at best a single stand-alone software attempt
to rectify a bad situation.

Compatablity doen't exist between Roxio's Drag & DROP and Ahead's InCD program.

I'm totally disappointed with the UDF format.
The whole idea of accessing a CD disk and using it like a floppy is still a dream in my opinion.

The second next best choice for "wannabe CD_RW user's" is CDR...end of story.

This experience was provided via Windows 2000 Pro SP4 including updates.
I've been trouble-shooting Windows and the programs/devices for 10 years PLUS...
I'm no expert...nor am I a rooky...MCSE, A+cert...etc

Final notes:

I just recreated the same error messages in Event Viewer today..
Event ID 9.....Source "sbp2port"
The description for Event ID ( 9 ) in Source ( sbp2port ) cannot be found. The local computer may not have the necessary registry information or message DLL files to display messages from a remote computer. The following information is part of the event: .

followed by Event ID 51....cdrom
An error was detected on device \Device\CdRom1 during a paging operation.

followed by Event 11....cdrom (55) Fifty-Five times in a row
The driver detected a controller error on \Device\CdRom1.

followed by Event Id 9...same (30) Thirty times in a row

The OS was hangin...extremely slow response to "click-events"

I had to unplug the Firewire cable and the DC power to terminate the ID 11 events
then the OS recovered.....

This was seen as two Events ID 11
followed by event 135
Received a device interface REMOVAL notification for device:
\\?\SBP2#BUSlink_&CDRW____&LUN0#0006ca0200006810#{ 53f56308-b6bf-11d0-94f2-00a0c91efb8b}
followed by Event 134
Received a device interface ARRIVAL notification for device:
\\?\SBP2#BUSlink_&CDRW____&LUN0#0006ca0200006810#{ 53f56308-b6bf-11d0-94f2-00a0c91efb8b}

This time Roxio was reading a UDF created disk....It's still operational after the recovery, but
I'm not happy......perhaps the UDF format and Microsoft driver "sbp2port" over firewire are the real problem????

Maybe a new OS???? ...


ron_of_orange 3:53pm, PDT