-
July 6th, 2001, 09:27 PM
#1
Failed Bios Flash
Have nothing after bios update. GA-7XZ dual bios Board. ? can i switch the bios chips on this board to get it to boot. Will order new bios asp. This is a Gigabyte board for amd tb 900 cpu.All I have is blank screen.
Thanks all
-
July 7th, 2001, 02:15 AM
#2
Yes, replacing the chips should do the trick.. strange I had the same once where flashing started without any options to save old BIOS... I ended up with a dead PC as well
-
July 8th, 2001, 06:18 AM
#3
Registered User
There should be special switch or jumper for switching beetwen chips (I read about it somewhere on their site). Then You can reprogram flash chip back using flash routine from good chip. Refer to manual,though.
-
July 8th, 2001, 10:43 PM
#4
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks