[RESOLVED] IBM network printer 17
Results 1 to 3 of 3

Thread: [RESOLVED] IBM network printer 17

  1. November 2nd, 2000, 08:05 AM #1
    AngelaB
    Guest

    Question IBM network printer 17

    We have an old IBM network printer 17 and have replaced the fuser (after getting half dark pages on prints) and still getting an error 50 which means that the fuser is overheating. Any suggestions before we call the technician?
    Reply With Quote Reply With Quote
  2. November 2nd, 2000, 09:02 AM #2
    AlienDyne
    AlienDyne is offline
    Registered User AlienDyne's Avatar
    Join Date
    May 1999
    Location
    Athens, GREECE
    Posts
    3,772

    Post

    Is this fuser the right one?
    Did you disconnect anything and forget to plug it back it?

    Please don't post the same questions on multiple forums! http://forums.windrivers.com/cgi-bin...ML/000426.html

    ------------------
    "Matter is passive. In spite of its power, it can't be controlled without the human mind." Sokrates

    My Hardware Info, Hardware Media and Computer History page
    Reply With Quote Reply With Quote
  3. November 2nd, 2000, 09:53 AM #3
    DonJ
    DonJ is offline
    MegaMod DonJ's Avatar
    Join Date
    Aug 2000
    Location
    San Antonio, Texas
    Posts
    2,692

    Post

    Hi,
    I'm not that familiar with IBM's lasers but with HP's, you must power off the printer from 10 to 20 minutes for the error to clear itself; even after replacing the fuser assy. Also the power supply feeding the fuser assy could be bad/low.
    Just a couple of ideas...
    Good Luck!
    DonJ
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules