Acer 310s scanner SCSI SW ??

roehrle · November 15th, 2004, 10:47 AM

On the back of my 310s there is a sw with positions 0-9..There is nothing in the manual about what position the SW should be on when you are going SCSI to SCSI. This scanner worked on my old computer but stopped working after trying to get it to work on a new computer.
Now I can't get it to work on either.

*DonJ* · November 15th, 2004, 11:39 AM

You didn't say which version of Windows you're using.

Acer's scanners are now supported by BenQ. Imaging Device Drivers

You can also find your Installation Manual for WinXP here in .pdf format. It says to set the SCSI ID to 2.

Normally, you should be able to set it up for any address except 7. That is usually reserved for the SCSI Interface itself.

Hope this helps out...Good Luck!

November 15th, 2004, 10:47 AM	#1
roehrle Registered User Join Date: Nov 2004 Posts: 17	Acer 310s scanner SCSI SW ?? On the back of my 310s there is a sw with positions 0-9..There is nothing in the manual about what position the SW should be on when you are going SCSI to SCSI. This scanner worked on my old computer but stopped working after trying to get it to work on a new computer. Now I can't get it to work on either.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SCSI ID problem with Agfa Duoscan HiD	yuno	Digital Imaging	5	April 17th, 2004 09:00 AM
need a scsi card for scanner	cabal	Tech-To-Tech	11	May 14th, 2002 10:28 AM
[RESOLVED] Acer SCSI Scanner	Westgate	Digital Imaging	1	October 9th, 2001 09:39 PM
[RESOLVED] acer scanner software	digisys	Digital Imaging	2	October 3rd, 2001 09:04 AM
[RESOLVED] HP SCSI scanner problem? Please help!	goin4it	Hard Drive/IDE/SCSI Drivers	1	December 12th, 2000 12:09 PM

November 15th, 2004, 11:39 AM	#2
DonJ MegaMod Join Date: Aug 2000 Location: San Antonio, Texas Posts: 2,655	You didn't say which version of Windows you're using. Acer's scanners are now supported by BenQ. Imaging Device Drivers You can also find your Installation Manual for WinXP here in .pdf format. It says to set the SCSI ID to 2. Normally, you should be able to set it up for any address except 7. That is usually reserved for the SCSI Interface itself. Hope this helps out...Good Luck!