SnapScan1212P very slow under Win 2000

01-27-2000, 11:00 AM

SnapScan1212P works very very very slow on my system (win2000) I installed it now fpr the third time and it doesn't get faster...
Is it a Win2000-Problem or am I using the wrong drivers ???
thx

04-02-2000, 04:58 PM

Where didi you fid privers for SnapScan 1212p. Pleas send me a link on my e-mail: crash@hi.hinet.hr

Thanks

02-14-2001, 06:28 PM

Could you please let me know where to get Win 2000 drivers for the Agfa 1212p

My e-mail is tdtazmania@hotmail.com

02-16-2001, 10:08 AM

Beta Drivers can be found at http://www.agfa.com/betasoftware/
It took a lot of fiddling around, but I got these to work in the end. I had problems with the parallel port. Agfa say your port should be set as EPP, but I couldn't get it to work. In the end I had to flash the bios on my Abit BH6 motherboard, then reset the parallel port to ECP+EPP and then everything worked. Hope this helps.

01-27-2000, 11:00 AM	#1
Spiegelberg Guest Posts: n/a	SnapScan1212P very slow under Win 2000 SnapScan1212P works very very very slow on my system (win2000) I installed it now fpr the third time and it doesn't get faster... Is it a Win2000-Problem or am I using the wrong drivers ??? thx

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

04-02-2000, 04:58 PM	#2
Krešo Guest Posts: n/a	Where didi you fid privers for SnapScan 1212p. Pleas send me a link on my e-mail: crash@hi.hinet.hr Thanks

02-14-2001, 06:28 PM	#3
tdtazmania Guest Posts: n/a	Could you please let me know where to get Win 2000 drivers for the Agfa 1212p My e-mail is tdtazmania@hotmail.com

02-16-2001, 10:08 AM	#4
tdtazmania Guest Posts: n/a	Beta Drivers can be found at http://www.agfa.com/betasoftware/ It took a lot of fiddling around, but I got these to work in the end. I had problems with the parallel port. Agfa say your port should be set as EPP, but I couldn't get it to work. In the end I had to flash the bios on my Abit BH6 motherboard, then reset the parallel port to ECP+EPP and then everything worked. Hope this helps.