I'm working on a Asus A7V Motherboard.
Its got 4 IDE Channels. Thats weird.
It hates my video card...(Wait for a future thread :)
Do you have any tips or any suggestions?
Thanks
Rogue
Printable View
I'm working on a Asus A7V Motherboard.
Its got 4 IDE Channels. Thats weird.
It hates my video card...(Wait for a future thread :)
Do you have any tips or any suggestions?
Thanks
Rogue
What's so special about 4 IDE channels? ;) You probably have got a MB revision with on-board an IDE Raid controller (most likely made by Promise).
What's about video card?
Whats werid is that I've never seen one like this. It has 2 highspeed and 2 normal.
It also went nuts when I tried to put in a new video card(4x slot, 4x card+should work). Its also refused to take anymore ram. It had 256MB PC-100, and it went nuts when I added another 128MB PC-100 or PC-133.(I had both) I didn't even get a POST beep.(Also when I put in the Video Card, I didn't get a POST beep)
It just seemed like it was a odd board.
Not an odd board plenty around like that
I have a Epox 8K5A3+ which has 6 ide controllers
2 normal and
4 on a highpoint controller
12 ide devices
Quote:
Originally Posted by Ferrit
Cool. Do you use all 12?
Check your power supply (use another one, if you can borrow it from someone)... The video card uses +3,3V and +5V from power supply (not sure about schematics of that particular board, though).
Check your memory sticks one by one using any good memory tester (like memtest86 or similar)
Quote:
Originally Posted by Ruslan
where do I get a ram tester?
How much dose it cost?
How do I use it?
It's free... ;)
http://www.memtest86.com
;)
Thanks A Lot!
You're welcome! ;)