Memory (Presario 2500 (2505EA)
Two weeks back I installed NFSU2, the game ran very slow so I decided to buy a 256 memory module to add; the game stayed the same, no improvement at all, even windows looked the same, so I downloaded some tools for benchmarking, did some tests, some results told me that memory runs slow (there are some discrepances between what BIOs says and what windows says); BIOS settings are to poor, it just has some very few options avaible and none of them are important so I can't, for example, enable audio device, select VGA source, etc.; my question is: what should I do? is there any way to get more BIOS settings (advanced settings)?
This are the specs:
Compaq Presario 2500 (2505EA)
Pentium 4 2.40GHz
448ram (64 to on board Radeon IGP 345M) (DDR)
This are the results from a memory test:
Memory Controller
Error Detecting Method None
Error Correcting Capability N/A
Enabled Error Correcting N/A
Supported Interleave One Way Interleave
Current Interleave One Way Interleave
Maximum Memory Size per Slot 512 MB
Supported Speed(s) 70 ns, 60 ns
Memory Module Voltage 3.3 Volts
Number of Memory Slots 2
Memory Module Config Handles $00, $01
Supported Memory Types
Supports Standard Type No
Supports Fast Page Mode Yes
Supports EDO Yes
Supports Parity No
Supports ECC No
Supports SIMM No
Supports DIMM Yes
Supports Burst EDO No
Supports SDRAM Yes
Memory Module
Socket Designation DIMM 1
Bank Connections RAS 0, RAS 1
Current Speed 60 ns
Current Memory Type DIMM, SDRAM
Installed Size 256 MB
Enabled Size 256 MB
Correctable Error Exists No
Uncorrectable Error Exists No
Memory Module
Socket Designation DIMM 2
Bank Connections RAS 0, RAS 35
Current Speed 60 ns
Current Memory Type DIMM, SDRAM
Installed Size Not Installed
Enabled Size Not Installed
Correctable Error Exists No
Uncorrectable Error Exists No
Physical Memory Array
Location Motherboard
Use System Memory
Memory Error Correction None
Maximum Capacity 1,073,741,824 Bytes (1,024.00 MB)
Number of Slots / Sockets 3
Memory Error Info Handle $FFFE
Memory Device
Memory Array Handle $1C
Memory Error Info Handle $FFFF
Total Width 64 Bits
Data Width 64 Bits
Memory Size 256 MB
Form Factor DIMM
Device Set 1
Device Locator J400
Bank Locator DIMM 1
Memory Type DRAM
Type Detail Synchronous
Memory Speed Unknown
Memory Device
Memory Array Handle $1C
Memory Error Info Handle $FFFF
Total Width 64 Bits
Data Width 64 Bits
Memory Size 256 MB
Form Factor DIMM
Device Set 1
Device Locator J401
Bank Locator DIMM 2
Memory Type DRAM
Type Detail Synchronous
Memory Speed Unknown
Memory Array Mapped Address
Starting Address $00000000
Ending Address $1FFFFC00
Memory Array Handle $1C
Partition Width 2
Memory Device Mapped Address
Starting Address $00000000
Ending Address $0FFFFC00
Memory Device Handle $1D
Memory Array Mapped Address Handle $1F
Partition Row Position 1
Interleave Position 0
Interleaved Data Depth 0
Thanks for any answer.
Best regards.
