September 5th, 2002, 02:27 PM
You may want to check this out,but it usually only occurs if you have Roxio CD-Direct installed.
http://support.microsoft.com/default.aspx?scid=kb;en-us;Q311466
Good Luck,
Paul
August 19th, 2002, 08:16 AM
I had a very similar problem trying to install winxp on an older Asus board. I tried everything from installing from the hard drive to removing devices, etc. There were always files that would not...
December 15th, 2001, 10:54 AM
I tried installing xp pro from dos without any luck. First I copied the I386 file to a new formated partition and tried to run the winnt32.exe. The message came up that xp cannot be installed from...
December 9th, 2001, 08:47 AM
I'm having a similar problem with a Memorex 1622. I triple boot, and this drive works just fine in Win98SE and Win2K with adaptec software. But I'm having no luck getting it to work in XP with XP's...
December 9th, 2001, 08:33 AM
All fixed...I re-booted with the WinXp disk and chose the option to reinstall to repair a prior installation. Also, in the BIOS, I changed the option to have plug & play controlled by the operating...
December 5th, 2001, 04:46 PM
Anyone else want want to give some imput here.Any ideas would be appreciated.
Paul
December 4th, 2001, 07:58 AM
I am logged in with full administrative rights. I even checked in Administrative Tools, Local Security Policy that I am granted the right to "Load and unload devise drivers".That is what is so very...
November 30th, 2001, 11:41 PM
Just installed winxp pro on a fresh partition on one of my hard drives so that I can triple boot between win93se, win2k and winxp.Winxp install went smoothly, recognized all devises and installed all...
November 28th, 2001, 04:08 AM
Just installed new ram in my son's system; pc133 256 meg x 2 for a total of 512 meg. The ram is recognized at POST and everything runs fine. The problem is that little white dots are appearing on the...
November 27th, 2001, 02:32 PM
I checked the cmos and setup and everything seems ok. The mb is an Abit BX6. Also, the memory is reported correctly at POST. It may be that the memory slot itself is starting to go.I did check-out...
November 27th, 2001, 08:13 AM
Running win98. everything seem to be running ok, except occaisionally at start-up, just after the POST screen, a flashing message appears:
"Warning : SPD Not Found at DIMM(s) 4", then everything...