-
December 7th, 2009, 08:33 AM
#3
Since you indicate you CAN get into Bios ('Now my hard drives will not show in the bios');
First, get ALL the data you can from your present Bios chip and write it down (see Step 9 here; http://support.gateway.com/s/tutorials/Tu_949670.shtml and read this; http://www.badflash.com/biosdownload.html )
Let's start off simple - does your Gateway have a floppy disk drive?
If so, you need to create a bootable floppy with the correct Bios flash program and Bios data (this would be from the Gateway site for your specific make and model and recognizing the hardware you are going to use, most importantly the CPU.
You then set Boot priority to (as it should always be) floppy, cd, hard drive.
Then insert the floppy, shut down, and restart and follow directions to Flash the Bios.
Failing that, order a replacement chip from an on-line Bios chip seller.
Some good points raised here; http://forums.techguy.org/hardware/7...-problems.html
Similar Threads
-
By El.Plates in forum BIOS/Motherboard Drivers
Replies: 10
Last Post: November 23rd, 2006, 06:15 PM
-
By kieree in forum BIOS/Motherboard Drivers
Replies: 18
Last Post: September 12th, 2006, 07:57 PM
-
By misterpadge in forum BIOS/Motherboard Drivers
Replies: 4
Last Post: July 19th, 2006, 04:47 AM
-
By Jaisol in forum BIOS/Motherboard Drivers
Replies: 2
Last Post: April 6th, 2000, 01:04 PM
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks