|
-
May 7th, 2001, 01:29 PM
#1
 Mirroring in Novell 4.11 After Installation?
How does one go about installing and mirroring on a second hard drive on an already established Novell 4.11 server?
The books at hand are all very clear on how to do this during installation but are mum about how to do it at a later date.
Thanks.
-
May 7th, 2001, 01:36 PM
#2
Registered User
Hey houseisland, haven't seen you around for a while. Anyway, if you ever need to access Netware 4.11 install options after the initial install, type LOAD INSTALL at the system console. Then go to "Disk Options" to configure mirroring. Just be careful with this utility, you can do some damage if you aren't careful!
-
May 7th, 2001, 01:43 PM
#3
-
May 15th, 2001, 09:09 PM
#4
Thanks again, MacGyver.
It went extremely well apart from taking two years for the mirror to generate.
-
May 16th, 2001, 01:46 PM
#5
Keep in mind that some of the best NetWare information I have ever recieved was from people on this site. - Good luck.
-
May 16th, 2001, 03:07 PM
#6
Registered User
I am going to be upgrading the hard disks in our office server in about 5 minutes, and I have been advised NOT to let NetWare do the mirroring, but to use ServerMagic instead. Goes a lot faster!
Originally posted by houseisland:
Thanks again, MacGyver.
It went extremely well apart from taking two years for the mirror to generate.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Reply With Quote
Bookmarks