I mistakenly posted this on the IDE Forum first.

I run windows 98 on my PC. I started out with a perfectly opperational CDROM drive, but when i installed my CD-RW i lost the use of my CDROM drive. Currently i have both CDRoms on the 2nd IDE Controlloer port. CD-RW on the far end slot and CDROM on the one below it. I have both connected to what i believe is the proper settings. CD-RW is on Master Jumper switch and CDROM is on slave setting.
At the Moment i have no DDefault CDROM Drive) drive showing in My Computer and i have no idea what is going on.
WHen i look in the System properties in device manager, under Hard Disk Controllers it shows a Black "!" on a Yellow field (under secondary Ultra ATA controller) and it says that
"The Device is either not present, not working properly or does not have all the drivers installed. (Code 10)"
then says below that
"Try Upgrading the device drivers for this device"
I tried updating the driver for it but the CDROM and the CR-RW are still not present.
I first noticed the problem when i tried to install the CD-RW Software with the Origninal CDROM Drive.

I havent done much else other than what i have stated. If anyone could help me with this, I would Be Extremely Grateful.

Thanks
L8R