I have a Trident 3D Image 9750 chipset display card with TV Out.
At the top of the card is says "HK8301 RE VB"
The display card worked fine apart from the fact that the TV output was permanently in black and white. After a while I realised that this was because the card was set to NTSC and I need PAL here in the UK.
The driver in win 98 has a dropdown box that says NTSC, but is disabled.
Looking at the card, the following is printed on it:
NTSC PAL
R3 4.7K OPEN
R25 OPEN 0 ohms

Therefore I did the fiddly soldering to set the card to PAL.
However, now as the computer boots up attached to a VGA monitor the screen is overlayed over itself many times until it gets into windows when it is fine.
When I switch to the TV Out mode the TV does not display anything at all!

I reset the resistors back to the NTSC setting and it does the same as it used to, so I haven't broken the card!

Does anyone have any ideas of how to set this card to PAL?

Olly