Hi,

I hope everyone is well, it's been a while.

I have a problem with a slave drive.
Computer has been working fine for the last few weeks after upgrading the hard drives to Master: 80G Maxtor Slave: 320G Maxtor.
The slave was divided into 2 partitions and has been fine up until a few minutes ago.

Basic System Info



The slave is seen in CMOS

http://i22.photobucket.com/albums/b3...g?t=1206975353

Also in Disk Management (but not as previously setup)

http://i22.photobucket.com/albums/b3...g?t=1206975473

But is not seen My Computer

http://i22.photobucket.com/albums/b3...g?t=1206975549

EnableBigLba is still enabled



What I did prior to this problem was, remove the Master drive and replaced with another to setup another copy of my OS on for emergency purposes. When I replaced the original 80G Maxtor Master the slave was missing although plugged in.

Why would it be missing? Any chance of getting it back as was?
There is stuff on there, not important stuff but could do with not having to replace it all again.



Regards,

Kevin