|
-
March 8th, 2009, 12:39 PM
#1
Registered User
Read write access problem
Windows Vista Premium. AMD 64 5000, 2.0Gb DDR2, Hitachi 400Gb.
Every time the PC boots, it blue screens with the error code 0x000000BE, and the error message "An attempt was made to write to read only memory".
It does this is normal mode, safe mode, and system repair.
Have tested memory, HDD, mobo etc and all are OK. In fact, an installation onto a new HDD went fine with the same hardware.
I have removed the HDD and scanned for viruses etc.
I cannot seem to get round this issue at all. Any ideas?
If this were XP, I would replace the usual files (default, sam, security, software and system) from a restore snapshot. Is there a similar method for Vista?
Last edited by ADS_Tech; March 8th, 2009 at 12:43 PM.
If the automobile had followed the same development cycle as the computer, a Rolls-Royce would today cost $100, get a million miles per gallon, and explode once a year, killing everyone inside.
Robert X. Cringely, InfoWorld magazine
Similar Threads
-
By korito in forum Tech-To-Tech
Replies: 0
Last Post: October 14th, 2007, 12:56 PM
-
By harddrive69 in forum Hard Drive/IDE/SCSI Drivers
Replies: 13
Last Post: July 22nd, 2007, 06:01 PM
-
By incredidome in forum Hard Drive/IDE/SCSI Drivers
Replies: 1
Last Post: August 21st, 2006, 10:42 AM
-
By marik in forum CD-ROM/CDR(-W)/DVD Drivers
Replies: 5
Last Post: September 16th, 2004, 03:55 AM
-
By rocknix in forum USB/Firewire
Replies: 0
Last Post: September 9th, 2004, 04:21 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Reply With Quote
Bookmarks