Making a wired network printer accessible over a wireless network

[pbolduc]

Hello,

Strange problem I ran into today. I was hoping someone could explain to me why it doesn't want to work when the printer uses TCP/IP natively to transmit and recieve information through a CAT 5 network jack.

Here is the scenario: The goals is to turn a wired network printer into a wireless accessible device. The Equiptment I have:
D-link DWG-2100AP (Working in Access Point Client Mode)
D-link DIR-655 Wireless Router (Internet Gateway\Router)
Samsung CLP-350N Network Printer.
Generic 4 port Switch

So I have configured the Access point to connect to the Wireless DIR-655. I have a laptop plugged into a switch which goes through the Access Point and wirelessly connects to devices behind the DIR-655 or it can access the internet. Computers behind the DIR-655 can access the internet and can access computers behind the access point DWG-2100AP.

My Problem: When I plug a Network printer into the switch behind the Access Point ( DWL-2100AP) computers behind the DIR-655 cannot access the printer. If I move the printer behind the DIR-655 instead of behind the access point computers behind the DWL-2100AP cannot access the printer.

The communication to the printer seems to break the minute the packets go wireless. Any suggestions as to why this happens? I thought these devices would be following protocol. The connection to each network device should be transparent.

As I mentioned before I can have a computer behind the access point access a computer behind the wireless router and vice versa. The printer is the only device that seems not to establish a connection between the two devices. There is no routing required. Devices behind the access point and the router are all on the same network segment of 192.168.1.x

Thank you for your time as it is much appreciated