The part where I don't specify a location and let it go as an unknown device, I tried that but I got the same result.

Onething did catch my attention- switching the parallel port to ECP.

Will check that.... hopefully that's the end. Usually I change the parallen port to ECP when i boot up the mbd the very first time, but I don't recall doing it on this one.

I will check and if it does help, report back

Thanks for all your help guys! *sob* you have been life savers quite a few times- I hope I can help someone like you guys do.

P.S. In the meantime if any of you has any more suggestions or comments, please do post them!


------------------
Say what?

[This message has been edited by pm4345 (edited February 12, 2001).]