<font face="Verdana, Arial, Helvetica, Verdana, Geneva, Arial" size="2">Originally posted by cyberhh:
What exactly are you looking for? You could create a custom harness to go from the 1236 wire standard to 1236 + 4578 harness at both ends and see if it works - just make sure that both harnesses are the same and that pins 123+6 are active on both ends. Also after creating the splitter harness you should use an end to end tester and test the entire run for continuity.

</font>
wow, i totally didnt see your post until after I posted. i feel stupid...

------------------
"You dumb bastard...it's not a schooner, it's a sailboat!"