-
July 17th, 2001, 02:02 PM
#1
Iwill Raid in DOS SUCKS anybody help ?
Anybody know how to speed up HD access on the IWill KK266-R in Dos ? I did see an article which hinted at there being a problem when raid was used in dos with this board but I can't find it now.
I have Raid active and configured for two raid 0 arrays spanning four ide drives. Average speed when in dos 70 MB min. I had exactly the same setup on an Abit KA7-raid board with an average speed in excess of 700 MB min. What the hells goin on, is the controller crap or is it a config problem ? The only difference between the two systems is the mobo. I did a clean install of everything including formating ALL the drives( 3 times ) still no joy. If anybody has an answer I'd be grateful. <IMG SRC="smilies/eek.gif" border="0"> <IMG SRC="smilies/eek.gif" border="0"> <IMG SRC="smilies/eek.gif" border="0"> <IMG SRC="smilies/confused.gif" border="0">
System :
Axia 1 gig @ 1450 FSB 138
I-Will KK266-R mobo
768 meg crucial memory
2 x IBM 20 gig ide drives ( Raid 0 )
2 x Maxtor 40 gig drives ( Raid 1 )
ATI Rage Pro graphics
On Board sound
2 x Plextor 16/10/40A CDWR
1 x Memorex DVD
-
July 18th, 2001, 08:47 PM
#2
Registered User
I use IWill boards and I might be able to help, but im not familiar with Axia. Is that the processor type? If so, I have never heard of them. Being that its the KK model im assumeing that its the AMD processor. If that is the case then I would say its a configuration error. I havent set up a system that powerfull with that board but I have had no problem in DOS with the access times.
this probably didnt help much but ill look into my own documentaion and check back if I find something...good luck!
-
July 20th, 2001, 09:45 AM
#3
Thanks Cygnus, yep axia is an AMD T/Bird, to business been trying different connection formats for the drives results below. All tests were done using the same ghost image of a 6 gig partion containing 700meg of data and copied from D secondary raid array to C primary raid array except for the CD test which I found surprising. Arrays set up as 32k stripe with 16k clusters.
1) Raid Array 0 = master & Slave on primary raid channel
Raid Array 1 = master & Slave on secondary raid channel
Speed = 47 mb/m
2) Raid Array 0 = master raid channel 0 & master raid channel 1
Raid Array 1 = secondary raid channel 0 & secondary raid channel 1
Speed 50 mb/m
3) Raid Array 0 = master raid channel 0 & secondary raid channel 1
Raid Array 1 = secondary raid channel 0 & Master raid channel 1
Speed 131 mb/m
4) CD primary on IDE 0
Speed 135 mb/m
As you can see from the above copying from the CD is fastest ?? DOH
Now the plot thickens, I use a zoom v.92 external modem on com 1. If I switch it off the speed of config 3 above rises to 315 mb/m. The modem IRQ is 3 the raid controller is 10.
Any ideas what the hells goin on ?
Even more clueless now
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks