RAID 5 failure
Results 1 to 4 of 4

Thread: RAID 5 failure

  1. February 20th, 2002, 12:23 PM #1
    HIESLanMan
    HIESLanMan is offline
    Registered User HIESLanMan's Avatar
    Join Date
    Feb 2001
    Location
    Atlanta, GA
    Posts
    154

    Post RAID 5 failure

    I just had two disks go down on me within 48 hours. I was using an Escalade 6800 IDE controller, with three drives set up in a RAID 5 configuration. I got a notice on Thursday afternoon that one went dead. I immediately did a backup, and swapped out the drive that night. I couldn't get the array to rebuild, however. After upgrading firmware and trying the rebuild a half-dozen or so times, I noticed that there were many errors on one of the other drives on the array. I couldn't fix these with chkdsk /f (that's all I had - anyone have suggestions for better software, I'm all ears!). Saturday morning the other drive finally died alltogether. I got some brand new drives, and still couldn't rebuild the array. Fortunately, I was able to fit all the data on one large drive and mirror it, so I only had one day of downtime during the week (let's hear it for good backups!)
    Has anyone else had two drives die in such a short period? Anyone have any tips on how I could set up better? Any horror stories?
    a LARTing we will go
    a LARTing we will go
    hi-ho the derrio
    a LARTing we will go
    Reply With Quote Reply With Quote
  2. February 22nd, 2002, 09:44 AM #2
    Cygnus
    Cygnus is offline
    Registered User Cygnus's Avatar
    Join Date
    May 2001
    Location
    Boca Raton, FL
    Posts
    491

    Post

    We had a similar problem recently but it turned out to be the RAID controller causeing write errors rather than the drives being bad. Are you sure it was the drives that were bad? Its running ok now on the same controller?
    Reply With Quote Reply With Quote
  3. February 27th, 2002, 09:45 PM #3
    HIESLanMan
    HIESLanMan is offline
    Registered User HIESLanMan's Avatar
    Join Date
    Feb 2001
    Location
    Atlanta, GA
    Posts
    154

    Post

    I have a suspicion that the card could possibly be at fault, but I'm not sure how to check. I do have drives working on it now, but no RAID. I just seems that the odds should be against having failures that close!
    Reply With Quote Reply With Quote
  4. March 13th, 2002, 11:09 PM #4
    houseisland
    houseisland is offline
    Registered User
    Join Date
    Jan 1999
    Location
    Canada
    Posts
    2,513

    Post

    This may not fit your situation exactly. But power is so important with raid arrays.

    If the RAID card still seems to be functional (say, in another system), if the drives still seem to work (say, after writing zeros and repartitioning), and if all you have really experienced is corruption of the array rather than true electrical/mechanincal failure of the drives, you might also try looking at your power supply/source.

    How many hard drives? How many CPUs? How many fans, including the little ones in hot swap drive bays, etc? How many adapter cards?

    What wattage power supply? What quality? Is there a UPS to isolate the power supply from spikes and brown outs?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules