DLGDIAG on a Western Digital 20gig
Results 1 to 4 of 4

Thread: DLGDIAG on a Western Digital 20gig

  1. December 7th, 2002, 02:00 AM #1
    Silverman
    Silverman is offline
    Registered User
    Join Date
    Nov 2000
    Location
    Green Bay, WI USA
    Posts
    654

    DLGDIAG on a Western Digital 20gig

    Anyone try removing EZBIOS with WD's Latest diagnostic tool?
    All tests says the drive is good but in advanced mode in install/setup to change or remove EZBIOS the drive isn't detected. What am I missing here?
    Reply With Quote Reply With Quote
  2. December 7th, 2002, 03:51 AM #2
    Garak
    Garak is offline
    Senior Member Garak's Avatar
    Join Date
    Jun 2001
    Location
    Hebburn, Tyne & Wear, North East England
    Posts
    2,448
    Hmm, did you let the drive boot then hit the key combo to boot from floppy?
    Reply With Quote Reply With Quote
  3. December 8th, 2002, 12:32 AM #3
    Silverman
    Silverman is offline
    Registered User
    Join Date
    Nov 2000
    Location
    Green Bay, WI USA
    Posts
    654
    Sorry for the late reply to your question, yes tried both ways, but I figured it out. The jumper was set to master on the drive originally so I moved it to cable select ran the diagnostics and wiped the drive in that mode, no problem at all. The switch to a Promise controller may have aided somewhat. It is much faster.
    Reply With Quote Reply With Quote
  4. December 8th, 2002, 01:58 AM #4
    Garak
    Garak is offline
    Senior Member Garak's Avatar
    Join Date
    Jun 2001
    Location
    Hebburn, Tyne & Wear, North East England
    Posts
    2,448
    okey doke - glad you sorte it..
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules