3dfx agp card

[blink]

hi all, got the above card but need drivers.it came out of a compaq 5700t.the chipset is 355-0025-001
f11834.10
9929 20005
taiwan 330
on the edge of the card it has 3dfx interactive
210-0383-001-ao
that # was in the fcc box.it wasn't listed in device mgr and i don't have clue to the model of the card.

[Rellik]

Based on what I have found, I belive that is a Voodoo3 based card

best place to try for drivers is http://www.voodoofiles.com

[NooNoo]

This may help I couldn't match up the numbers quite...

You could use the compaq drivers But they are for 98 - although they should work in ME.

[Rellik]

here's another page from one of the sites Noo posted which may provide a little more help.

Unfortunatelty, from what i saw based on the these pages, none of the numbers match exactly:

210-0383-001-ao is close to 210-0382-00x which is a Voodoo III 2000 LC

And yet 355-0025-001 is close to 355-0025-221 which is a VSA 101(whatever that is)

[NooNoo]

Originally posted by Rellik
here's another page from one of the sites Noo posted which may provide a little more help.

Unfortunatelty, from what i saw based on the these pages, none of the numbers match exactly:

210-0383-001-ao is close to 210-0382-00x which is a Voodoo III 2000 LC

And yet 355-0025-001 is close to 355-0025-221 which is a VSA 101(whatever that is)

yes its a made for compaq special... good luck with it!

[theredguy]

What os are you planing to run it under, if its xp then it might just recognise the voodoo chip set and put the drivers in itself.

[blink]

hi all thanks for the replies. i'll check out the the links in a few and let you know the outcome ; the os is 98.