hey all!

I'd like to enable sideband addresssing and fastwrites(geforce3ti200)...my bios says that I have fast write enabled and there's no spot for enabling sideband addressing (mobo=kt3 ultra-aru). Powerstrip says that fast write is still disabled and i can't figure out how to enable sideband...here's the report:

Diagnostic report - generated on 1/17/2004
------------------------------------------------------------------------------
PowerStrip build - 425
Windows build - v.5.1.2600.2.Service Pack 1
DirectX build - v.5.3.0000000.900 built by: DIRECTX
OpenGL renderer - (n/a)

System board
------------------------------------------------------------------------------
CPU speed - 1706 MHz
Type - VIA
AGP aperture - 128 MB
AGP transfer mechanism - DMA
AGP non-local memory - 69.6 MB
AGP driving value - 77h (N-ctrl=7, P-ctrl=7)
AGP revision - 2.00
AGP transfer rates supported - 1x, 2x, 4x
Current AGP transfer rate - 4x
Sideband addressing - hardware support, but currently disabled
Fast write protocol - hardware support, but currently disabled
AGP texturing - Enabled

Graphics card #1
------------------------------------------------------------------------------
Identity - NVIDIA GeForce3 Ti 200
Memory clock - 400.90 MHz
Engine clock - 175.00 MHz
IRQ - 16, shared
AGP revision - 2.00
AGP transfer rates supported - 1x, 2x, 4x
Current AGP transfer rate - 4x
Sideband addressing - (n/a)
Display driver - nv4_disp.dll, v.6.14.01.4345
DirectX driver - nv4_disp.dll, v.6.14.01.4345
Attached monitor - SNY0191 (Plug and Play Monitor)
Monitor caps (1) - 2984x1680, 105kHz, 130Hz

Device enumeration
------------------------------------------------------------------------------
NVIDIA GeForce3 Ti 200 (020110DEh) - using IRQ16
VIA CPU-to-PCI/AGP bridge (30991106h)
VIA PCI-to-PCI/AGP bridge (B0991106h)
Intel Ethernet controller (12298086h) - using IRQ18
Creative Labs Audio device (00021102h) - using IRQ19
Creative Labs Input controller (70021102h)
NEC Universal serial bus (USB) (00351033h) - using IRQ18
NEC Universal serial bus (USB) (00351033h) - using IRQ19
MicroStar Universal serial bus (USB) (00E01033h) - using IRQ16
Promise RAID controller (5275105Ah) - using IRQ19
VIA PCI-to-ISA bridge (31471106h)
VIA IDE controller (05711106h)
VIA Universal serial bus (USB) (30381106h) - using IRQ21
VIA Universal serial bus (USB) (30381106h) - using IRQ21


Is there a way to enable sideband addressing on the kt3???

Thanks!