WiFi Parabolic Dish Add-On
Results 1 to 3 of 3

Thread: WiFi Parabolic Dish Add-On

  1. December 20th, 2009, 10:35 AM #1
    CCT
    CCT is offline
    Registered User
    Join Date
    Feb 2006
    Location
    Canada, Eh!
    Posts
    4,091

    WiFi Parabolic Dish Add-On

    Interesting site - I am going to make a couple since I get poor reception/transmission from a back-basement room to the router upstairs.

    http://www.freeantennas.com/
    Reply With Quote Reply With Quote
  2. January 14th, 2010, 08:52 AM #2
    CCT
    CCT is offline
    Registered User
    Join Date
    Feb 2006
    Location
    Canada, Eh!
    Posts
    4,091
    Well, the update.

    I took a Tim Horton's coffee can, cut the bottom out (top already gone since the wife drank it all) and then proceeded to cut the can in half vertically to create 2 dishes.

    Using the curvature template at the site I noted above, I shaped the 2 dishes and then positioned them behind each of the aerials on my Linksys router.

    The signal strength, which was LOW in the back basement went immediately to GOOD.
    Reply With Quote Reply With Quote
  3. January 14th, 2010, 12:28 PM #3
    NooNoo
    NooNoo is offline
    Driver Terrier NooNoo's Avatar
    Join Date
    Dec 2000
    Location
    UK
    Posts
    31,824
    Nice job!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Possible for WiFi router to connect to ADSL Modem with WiFi?
    By Phoebus in forum Internet and Networking
    Replies: 1
    Last Post: October 11th, 2006, 03:13 AM
  2. Wifi card or router?
    By ClickHere2Surf.com in forum Tech-To-Tech
    Replies: 22
    Last Post: March 31st, 2005, 04:55 AM
  3. DVD Burner - add or replace
    By Icecake in forum CD-ROM/CDR(-W)/DVD Drivers
    Replies: 3
    Last Post: December 10th, 2004, 08:46 PM
  4. Corporate WIFI Solution??
    By spyder0552 in forum Networking
    Replies: 2
    Last Post: September 7th, 2004, 11:03 AM
  5. Need to add CD Drivers, but not to the Config.SYS
    By Pinnacle in forum Tech-To-Tech
    Replies: 8
    Last Post: March 3rd, 2001, 10:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules